DIY Overhead Ceiling Electrical Light Fixture Removal

The first step in this DIY Overhead Ceiling Electrical Light fixture Removal Jon s to turn off the power. You'll want to do this first so you don't shock yourself. The next step is to unscrew the glass fixture cover by unthreading the center holding nut that holds the glass cover in place. Be careful as sometimes this could cause the glass to come down on you or drop on the floor depending on who installed it. Then unscrew the lightbulb. At this point you can unthread the center piece if need be, not required though.

The next step is to get your cordless drill and unscrew or loosed the two screws hold this into place. These are attached to the light fixture electrical box itself. Now give the fixture a little twist and it should come loose. If it's been up there a long time, expect some insulation, dust, and debris to come out so try not to get this on your face or into your eyes. Before touching any wire, I recommend doing a second check to make sure there is no current going through the wires. I always take three precautions when doing this kind of work. I shut the power off at the breaker, shut the power off at the switch, then finally use my voltage tester to make sure I don't get shocked. Once you've confirmed no current flowing through the wires you are about to touch, go ahead and untapped and unthread the existing house wire to remove this old fixture.

Here's an amazon link to a voltage tester: https://amzn.to/2ltV77h