DIY How to Install a Kwikset Door Handle and Deadbolt: Gatehouse Metal H...

The above step by step tutorial is a Kwikset Brand keyed entry door knob and deadbolt installation into a newly installed home security door. This door knob and deadbolt set was purchased at Lowe's Home Hardware Store. I have been pleased with the ease of installation of Kwikset brand door knobs and deadbolts. I've used them quite a lot over the years for various door installations.

The question many people have is "Can this kwikset door knob be used on metal security doors?" or "Can a kwikset doorknob that I purchased from Lowe's that would normally be used on a wood door be used on a Gatehouse Brand metal security door?".  First of all the answer is most definitely as I have installed numerous metal security doors during work as a handyman. The gatehouse brand door is nice because it's cheap, easy to install, and effective. Kwikset door handle and deadbolt combination kits are great and can be purchased at an affordable price. In this video I cut open the packaging with some scissors and pulled out the door knob and deadbolt set I need. I was doing a couple different doors this day so the combination pack was perfect. The next thing I did was insert the latch into the door intel for a loose test fit. The nice thing about it is that the threads and holes for the assembling screws are pre-drilled and tapped to standard sizes making for an easy installation. The next part is to install the inside and outside handle portion. To do this the handles need to be in the unlocked position. The flat on the door handle matches the flat on the latch insert so it can only be installed one way but if it's locked it will cause you some grief in trying to get the thing together. Once it's loosely together it's time to install the set screws. Trying to get these to line up can be a little bit of a pain sometimes. If you have an extra set of hands it's nice if the other person can hold pressure on the other side while you try to find the hole with your set screws. Once you've found the holes snug them up a bit but don't tighten all the way just yet. Once everything turns and opens and closes with no binding and functions as it should, secure the latch mechanism with the provided screws and tighten all the way. Now tighten the door knob set screws all the way. Now it's good to go as long as there is no binding or sticking. If it binds or sticks I have had to back the set screws off a 1/4 turn or so. Repeat the steps for the deadbolt assembly. Don't forget to make sure it is the right side up=). It really won't affect the function of the deadbolt if you have it 180 degrees upside down but the writing will be upside down and the key will go in upside down. I have made this mistake more than once being in a hurry installing these.

www.diy-technician.com