DIY Woodworking Making Cedar Garden Planter Boxes | Easiest Raised Bed D...

Gardening season is upon us and its time to grow your favorite crops in using this super easy raised garden bed design. I happened upon some scrap cedar from one of the local fencing places and made a couple of these for relatively free. You could get by with just a table saw and some screws if that's all you had and you could wind up with the same product. I like to use a combination of a table saw, chop saw, brad nailer and cordless drill with a few self tapping screws to hold the corners together for the long term. Not shown in this video is that I started using Romex wire staple type fasteners to hold the boards up against the frame. The brad nailer will hold just fine as the force of the dirt, when filled, pushes out against the boards so they won't as easily come loose but the Romex wire staples or some small wood screws or nails will work even better. This simple design is one that most inexperienced folks can use. The steps are as follows:

1. Cut four 2 X 4's to 30" in length 

2. Using a table saw, rip those in half, lengthwise making 8 pieces

3. Cut 45 degree corners on all pieces

4. Using table saw, cut notch (ledge) into each piece

5. Nail corners together making two full picture frame structures identical to each other

6. Cut 16" wood slats

7. Nail slats into identical top and bottom frames

8. Using self tapping screws, screw into the corners 

Now just fill it with topsoil and plant your favorite crop.

Please visit my website: https://www.diy-technician.com

DIY Pallet Planter Box-Raised Beds for Gardening

I found myself with quite the collection of pallets just begging to be used for a project. I planned on a garden the year I made some raised beds. Once I knocked all of the nails out of the pallet boards I tried to reuse as many of the nails as I could. Some of them required a little bit of straightening. Be careful when cutting pallets on a table saw for the inherent risks that accompany using this saw but also because many times there are nails buried inside the wood that you don't readily see from the outside. I've hit a few nails with the table saw and you know it when you hit one. This project was relatively simple, just created the bottom square then nailed some vertical side pieces in. After that I just went around and nailed all of the boards to the vertical side pieces. Once I had it flush with the top I cut some boards for the trim at 45 degree angles in the corners for a specific look. I decided not to paint them but as an idea you could paint them the same color as your house, shed, or barn. In this project I had some extra boards so I created a bottom for this but really there is no need if you don't plan on moving them. They are super heavy when they are full of dirt anyway. Not only that but once you start watering whatever plants go in there the boards are going to start rotting. I had some triangular pieces left from one of the pallet disassemblies so they were a perfect fit for the bottom corners. You can't go wrong using pallets to make your planter boxes.

Tools used:

Table Saw: https://amzn.to/31W6epw

Cordless Drill: https://amzn.to/31WRgiO

Brad Nailer: https://amzn.to/30UA50b

Air Compressor: https://amzn.to/35ftvop