DIY Pallet Planter Box-Raised Beds for Gardening

I found myself with quite the collection of pallets just begging to be used for a project. I planned on a garden the year I made some raised beds. Once I knocked all of the nails out of the pallet boards I tried to reuse as many of the nails as I could. Some of them required a little bit of straightening. Be careful when cutting pallets on a table saw for the inherent risks that accompany using this saw but also because many times there are nails buried inside the wood that you don't readily see from the outside. I've hit a few nails with the table saw and you know it when you hit one. This project was relatively simple, just created the bottom square then nailed some vertical side pieces in. After that I just went around and nailed all of the boards to the vertical side pieces. Once I had it flush with the top I cut some boards for the trim at 45 degree angles in the corners for a specific look. I decided not to paint them but as an idea you could paint them the same color as your house, shed, or barn. In this project I had some extra boards so I created a bottom for this but really there is no need if you don't plan on moving them. They are super heavy when they are full of dirt anyway. Not only that but once you start watering whatever plants go in there the boards are going to start rotting. I had some triangular pieces left from one of the pallet disassemblies so they were a perfect fit for the bottom corners. You can't go wrong using pallets to make your planter boxes.

Tools used:

Table Saw: https://amzn.to/31W6epw

Cordless Drill: https://amzn.to/31WRgiO

Brad Nailer: https://amzn.to/30UA50b

Air Compressor: https://amzn.to/35ftvop